Bnd50 Se36 Instructions Full !link!

Restores active system control, running programs exactly at your assigned times.

Plug the appliance cord into the outlet located on the side of the timer. 🛠️ Maintenance and Advanced Troubleshooting The Timer is Not Turning On

The BND50-SE36 is characterized by its fully integrated control panel, located along the top edge of the door to maintain a seamless exterior aesthetic. bnd50 se36 instructions full

Before configuring the device, verify that your electrical loads fall within safe operating boundaries: 230V–240V AC, 50Hz Max Load Current: 13A to 16A resistive maximum Maximum Wattage: 3,120W to 3,500W limit

| Mode | LED color | Behavior | |------|-----------|----------| | | Green | Press remote button → relay ON. Press again → relay OFF. | | Momentary | Red | Relay stays ON only while remote button is held. | | Latching | Blue | Relay changes state with each remote press, survives power cycle. | | Timer (1–60s) | Yellow | Relay turns ON for set seconds then auto-OFF. | Restores active system control, running programs exactly at

: 16A, 3680W (e.g., heaters, standard lamps)

Press the CLOCK button to save changes and exit back to the main time screen. Before configuring the device, verify that your electrical

If the LCD screen is blank or displays corrupted segments, remove the device from the wall outlet. Use the tip of a pen or paperclip to press the small, recessed RESET (or R ) button.