Cwfl-6000 Manual Here

Strictly never run the chiller without water . The tank must be filled until the gauge reaches the green (NORMAL) range before startup.

The water loop is too hot. Check if the laser load exceeds 6kW, clean the condenser dust filters, or inspect the refrigerant level.

Press to save the setting and return to the main display. Adjusting Target Water Temperature (In Constant Mode)

Deionized (DI) water (ensure conductivity stays within the laser manufacturer's limits). cwfl-6000 manual

Never use tap water, river water, or mineral water, as they cause scale buildup and clog internal channels. Filling Procedure Locate the water fill port on top of the reservoir. Observe the water level gauge on the back of the chiller.

on startup, your 3-phase wiring order is incorrect and needs adjustment. Air Purge:

The water temperature adjusts automatically based on the ambient temperature (ideal for preventing condensation). Strictly never run the chiller without water

Well-documented calibration processes let technicians distinguish between field-adjustable settings and factory-sealed calibrations, preserving traceability and warranty.

Technical tone should be precise but accessible: concise imperative steps for procedures, while reserving explanatory text for conceptual sections.

The S&A Teyu CWFL-6000 is a dual-circuit industrial chiller designed for 6000W fiber lasers, offering precision cooling for both the laser source and optics. Key operations include maintaining proper water levels, ensuring 1-1.5 meters of clearance, and performing regular maintenance to prevent scale and dust buildup. For full setup, operation, and maintenance guidelines, consult the Scribd document . CWFL-6000 Manual - 20221209171442 | PDF | Power Supply Check if the laser load exceeds 6kW, clean

: Do not run the system dry. Remove the filler cap and top vent, and fill the tank with deionized, distilled, or purified water until the level is within the green "NORMAL" range on the water level indicator.

Press the < key to check the water temperature of the two systems (high and low temperature).

Remove the side dust plates by pressing the snap-on buttons. Blow away accumulated dust using compressed air. Clean filters maintain optimal heat dissipation.