Exide 2100 Rp Charger Manual Free Free Here

Avoid areas with high humidity, direct moisture, conductive dust, or flammable materials. Electrical Connections

Check main power connection and the mains fuse.

Ensure the charger is unplugged from the wall socket.

You have connected the red clamp to the negative terminal and the black clamp to the positive terminal. Turn off the charger and swap the clamps. exide 2100 rp charger manual free

Ensure AC power at the breaker panel is completely off.

Inspect the internal transformer coils for signs of discoloration or burnt enamel varnish.

Used to balance out cell voltages and eliminate acid stratification in flooded lead-acid batteries. Pressing this adds an extra 2 to 3 hours of low-current charging onto the end of a standard cycle. Equalization should be performed once every 5 to 10 cycles, typically over a weekend. Avoid areas with high humidity, direct moisture, conductive

You will see a series of heavy-gauge wires leading to terminals labeled 208, 240, and 480 (or similar local voltage variants).

Allow the unit to cool; check ventilation and ensure the battery ambient temperature is under 115°F (46°C).

If your incoming shop voltage is 240V but the charger internal jumps are set to 208V, the charger will run excessively hot and overcharge the battery. Conversely, undersetting the taps will cause low output and extended charge times. You have connected the red clamp to the

: If the red light stays on continuously, the battery may be deeply discharged or defective.

The Exide 2100 RP (Rapid Power) series is designed to charge motive power batteries used in forklifts, pallet jacks, and other electric industrial vehicles. It utilizes advanced microprocessor controls to deliver a precise charge, preventing both undercharging and overcharging, which are the leading causes of premature battery failure. Key Technical Features