Fagor Fi80 Dishwasher Manual [hot] | 1080p × 720p |
Drain the tank entirely, refill with clean water, and run one more cycle to flush out remaining chemicals. Troubleshooting Error Symptoms
| Section | Content | |---------|---------| | | Water supply connection (3/4" threaded hose), drain hose height (min 50 cm, max 110 cm), leveling feet adjustment, electrical connection (220-240V, 50Hz, 10A fuse). | | Control Panel | Explanation of program selector dial, start/pause button, half-load button (if equipped), and indicator lights (salt, rinse aid, end of cycle). | | Programs | Typical cycles: Intensive (70°C), Normal (65°C), Eco (50°C), Rapid (30-40°C), Glass/Soak. | | Water Softener | How to set the softener level (based on local water hardness: H1 to H5) and refill dishwasher salt. | | Filters & Maintenance | Cleaning the triple filter system (coarse, fine, microfilter) and spray arms. | | Error Codes | E1 (water inlet issue), E2 (drain problem), E4 (flood protection active). |
As Fagor no longer provides official support, any repair carries risk. Always unplug the dishwasher before opening it. If your FI80 has a major electronic failure (control board), repair may not be cost-effective compared to a modern replacement.
Before installation or operation, ensure your facility meets the utility requirements for the Fagor FI80. Proper utility connections prevent performance drops and component damage. Electrical Specifications 208–240V Phase: Available in 1-phase or 3-phase configurations Total Power: Approximately 6.6 kW fagor fi80 dishwasher manual
The Fagor FI-80 typically requires a three-phase electrical connection (400V/3N~/50-60Hz) or a single-phase configuration (230V/1N~), depending on the specific regional sub-model. It features high-power heating elements in both the wash tank and the rinse boiler to ensure rapid temperature recovery between cycles. Plumbing Connections
The machine features a safety microswitch. If the hood is not fully closed, it will not operate. Dishwasher Fails to Heat Up
Hard water causes calcium scale to build up on the heating elements, forcing them to use more energy and eventually burn out. Drain the machine and refill it with fresh water. Drain the tank entirely, refill with clean water,
Requires a 1-1/2" drain line. The FI80 usually relies on gravity drainage, meaning the floor drain must be lower than the machine base unless an optional drain pump is installed. Control Panel Overview & Cycle Selection
He sat on the kitchen floor, manual in lap, and flipped to the "Fault Codes" section.
Press the cycle start button. The machine will wash for roughly 90 seconds and rinse for 30 seconds. | | Programs | Typical cycles: Intensive (70°C),
Dishes not coming out clean or dry is a common frustration. The manual provides specific guidance, and here are the main causes:
Insert the overflow tube into the drain slot inside the wash tank. Close the dishwasher door.
Run 3 to 4 long cycles (180 seconds) without any dishes inside.