Magnat Classic 360 Bedienungsanleitung 13pdf Hot Jun 2026

The operational section of the manual describes the controls located on the front of the master speaker:

4 x 40 Watts or 2 x 120 Watts bridged RMS Power Output (2 Ohms): 4 x 60 Watts Frequency Response: 5 Hz – 50,000 Hz Total Harmonic Distortion (THD): < 0.05% Signal-to-Noise Ratio: > 100 dB Input Sensitivity: 400mV – 4V Low-Pass Filter: 40 Hz – 300 Hz (Variable) High-Pass Filter: 40 Hz – 300 Hz (Variable) Terminal and Connection Layout

ℹ️ Nutzer empfehlen, alle Regler zunächst auf 80 Hz zu stellen – das ist ein guter Ausgangspunkt für viele Systeme. magnat classic 360 bedienungsanleitung 13pdf hot

This setup is ideal if you want to power front door speakers and rear deck speakers simultaneously.

Elektrotanya bietet ein mit dem Schaltplan der "New-Version" – hilfreich für die Reparatur oder wenn du die Elektronik besser verstehen möchtest. The operational section of the manual describes the

Inspect the physical fuses built directly into the amplifier chassis. Check the main inline fuse near your car battery. Verify that the +12V power wire, ground wire, and the thin remote turn-on wire (REM) are all receiving proper voltage using a multimeter. Whining Noise Matching the Engine RPM (Alternator Whine) Cause: Ground loop interference.

Verbinde die deines Autoradios mit den Cinch-Eingängen der Endstufe. Du hast hier mehrere Optionen: Inspect the physical fuses built directly into the

| Parameter | Wert | |---|---| | | 4 | | RMS-Leistung (4 Ohm) | 4 x 80–90 W (je nach Quelle) | | RMS-Leistung (2 Ohm) | 4 x 120 W | | Brückenleistung (4 Ohm) | 2 x 180–240 W | | Frequenzgang | 5 Hz – 50 kHz | | Tiefpass/ Hochpass | 40–300 Hz regelbar | | Signal-Rausch-Abstand | 100 dB | | Bass Boost | 0–12 dB bei 45 Hz | | Abmessungen (B x H x T) | ca. 419 x 54 x 257 mm | | Gewicht | ca. 4,3 kg | | Stromaufnahme (max.) | ca. 30 A |

Connect this to the remote turn-on wire (usually blue/white) coming from your aftermarket head unit. This tells the amplifier to turn on when your radio powers up.

Understanding the power distribution of the Magnat Classic 360 ensures you do not overload the internal circuitry. 4-channel power amplifier.

Always disconnect the negative battery terminal before starting.

The operational section of the manual describes the controls located on the front of the master speaker:

4 x 40 Watts or 2 x 120 Watts bridged RMS Power Output (2 Ohms): 4 x 60 Watts Frequency Response: 5 Hz – 50,000 Hz Total Harmonic Distortion (THD): < 0.05% Signal-to-Noise Ratio: > 100 dB Input Sensitivity: 400mV – 4V Low-Pass Filter: 40 Hz – 300 Hz (Variable) High-Pass Filter: 40 Hz – 300 Hz (Variable) Terminal and Connection Layout

ℹ️ Nutzer empfehlen, alle Regler zunächst auf 80 Hz zu stellen – das ist ein guter Ausgangspunkt für viele Systeme.

This setup is ideal if you want to power front door speakers and rear deck speakers simultaneously.

Elektrotanya bietet ein mit dem Schaltplan der "New-Version" – hilfreich für die Reparatur oder wenn du die Elektronik besser verstehen möchtest.

Inspect the physical fuses built directly into the amplifier chassis. Check the main inline fuse near your car battery. Verify that the +12V power wire, ground wire, and the thin remote turn-on wire (REM) are all receiving proper voltage using a multimeter. Whining Noise Matching the Engine RPM (Alternator Whine) Cause: Ground loop interference.

Verbinde die deines Autoradios mit den Cinch-Eingängen der Endstufe. Du hast hier mehrere Optionen:

| Parameter | Wert | |---|---| | | 4 | | RMS-Leistung (4 Ohm) | 4 x 80–90 W (je nach Quelle) | | RMS-Leistung (2 Ohm) | 4 x 120 W | | Brückenleistung (4 Ohm) | 2 x 180–240 W | | Frequenzgang | 5 Hz – 50 kHz | | Tiefpass/ Hochpass | 40–300 Hz regelbar | | Signal-Rausch-Abstand | 100 dB | | Bass Boost | 0–12 dB bei 45 Hz | | Abmessungen (B x H x T) | ca. 419 x 54 x 257 mm | | Gewicht | ca. 4,3 kg | | Stromaufnahme (max.) | ca. 30 A |

Connect this to the remote turn-on wire (usually blue/white) coming from your aftermarket head unit. This tells the amplifier to turn on when your radio powers up.

Understanding the power distribution of the Magnat Classic 360 ensures you do not overload the internal circuitry. 4-channel power amplifier.

Always disconnect the negative battery terminal before starting.