Multibeast 1130 Mojave ^new^ Jun 2026

Choose UEFI Boot Mode if you installed using UEFI.

Choose the driver corresponding to your Ethernet port. For example, choose IntelMausiEthernet for most Intel boards, or RealtekRTL8111 for Realtek gigabit ports.

For those who dare to push the boundaries of their Mac's capabilities, Multibeast 1130 on macOS Mojave offers a world of untapped potential. As a powerful tool for customizing and enhancing your Mac's hardware, Multibeast has long been a favorite among enthusiasts and hackers alike. In this article, we'll dive deep into the world of Multibeast 1130 on macOS Mojave, exploring its features, benefits, and the process of installing and configuring it. multibeast 1130 mojave

macOS Mojave has a 15-port limit. MultiBeast attempts to patch this, but often you need to use the tool to create a custom USB map for your specific case ports.

: Installs the Clover bootloader to your system drive so you don't need a USB to boot. Driver Collection (Kexts) Choose UEFI Boot Mode if you installed using UEFI

Go to the Build tab, verify selections, click Install , and enter your password.

This guide assumes a fresh installation of macOS Mojave on a UEFI-based system (the standard for modern PCs). The process for older BIOS (Legacy) systems will differ slightly. For those who dare to push the boundaries

Released by the community at tonymacx86.com, was the "all-in-one" post-installation tool specifically updated for macOS Mojave 10.14.5 and higher . Its "story" is one of simplification:

Ensure you did not select multiple audio layout IDs. If audio fails, you may need to open your config.plist file inside your EFI partition and manually experiment with the audio layout ID numbers (e.g., 1, 2, 11) that match your specific Realtek chip. MultiBeast vs. The Modern Hackintosh Era (OpenCore)

完成 macOS Mojave 的初始安裝後，進入系統。打開你的安裝隨身碟或下載文件夾，將 複製到「應用程式」或桌面，然後雙擊啟動。